|
Post by modelupgrades on May 11, 2019 22:53:25 GMT
I have just programmed a loco with a 4 digit address. When I go into the DCC control section when holding the address button down to add the loco address using the 4 numbering columns it will only allow me to add a 3 digit address up to 127. I have programmed the decoder cv29 to accept 4 digit address.
|
|
|
Post by LC-DCC Designer on May 12, 2019 7:35:10 GMT
You must configure the DCC system using the "DCC Configuration" button. This allows you to set-up 7/14 bit engine address, 28/128 speed steps, current overload detection etc.
|
|
|
Post by modelupgrades on May 12, 2019 10:50:52 GMT
Thanks All sorted now
|
|