|
Post by bluedot on Jul 21, 2019 13:08:11 GMT
I'm going to give building one of these Low Cost DCC's a go. I only need a very simple setup, basically to test DCC enabled engines on a single piece of track.
I'm going to go with the Standard STM32F103 Controller with INA219 setup.
I've done some stuff before on the Arduino so am comfortable with soldering and following wiring but I was wondering if someone could recommend what PSU I could use for the input to the INA219 ?
Thanks.
|
|
|
Post by LC-DCC Designer on Jul 22, 2019 17:22:00 GMT
I use this type of power supply:
Power Supply Universal Adapter Charger for Multi Laptop Notebook 96 Watts from eBay. It can do from 12V to 19V.
But this may be a little overkill if you are just building a basic single piece track. So I have also used a simple 12V 1A PSU for OO gauge.
Regards John
|
|
|
Post by bluedot on Jul 22, 2019 18:41:54 GMT
Thanks, just ordering the bits now...
|
|