|
|
Post by flyingalan on Jul 29, 2019 0:10:42 GMT
Can you confirm that the current software uses address 0x48 for the I2C bus communication with the ADS1115 4 potentiometer interface ?
Thanks and regards
Alan
|
|
|
|
Post by LC-DCC Designer on Jul 31, 2019 7:40:46 GMT
Yes it is 0x48 - address pin connected to ground.
|
|
|
|
Post by flyingalan on Jul 31, 2019 14:56:10 GMT
Thanks, I'm provisioning dual ADS1115 in hope you eventually implement the second set of 4 analogue to make 8 total. Hence my question so that I set this first ones address correct.
My controller has been slow going recently due to other commitments, however back to it now and hoping to complete soon.
thanks and regards
Alan
|
|
|
|
Post by flyingalan on Oct 6, 2019 14:48:08 GMT
Hi I wonder if there is any progress in adding a second ADS1115 to the software allowing total of 8 potentiometers.
thanks and regards
Alan
|
|
|
|
Post by LC-DCC Designer on Oct 8, 2019 18:29:29 GMT
I have been side tracked adding support for extended accessory packets. So I intend to add the 8 channel potentiometer support into the next release along with extended accessory packets. This should be some time in the next couple of months.
|
|
|
|
Post by flyingalan on Oct 11, 2019 17:11:46 GMT
Thanks, look forward to new release.
Alan
|
|
