Failed to read DCC Controller version

colmac
New Member

Posts: 2

Failed to read DCC Controller version Aug 22, 2022 22:59:44 GMT

Quote

Post by colmac on Aug 22, 2022 22:59:44 GMT

Hi. I am new to DCC and in the process of setting up my LC DCC controller. I have built a M3 design with an INA219 current monitor as per instructions on the hardware guide. I have a 15v power supply and the USB is connected to my Windows PC. A red light is showing on the STM32F103 Blue Pill Board. I have purchased the software via Ebay but have yet to receive the licence. I have downloaded and unzipped the LC DCC software. When I run the application I get an Error message - Failed to read DCC controller version. I am not sure where to go from here. How can I check that all my soldering is OK and I have not corrupted the board? Cheers. colmac

LC DCC Designer Guest	Failed to read DCC Controller version Aug 23, 2022 13:13:27 GMT Quote Select Post Deselect Post Link to Post Back to Top Post by LC DCC Designer on Aug 23, 2022 13:13:27 GMT Is the LED on the M3 board flashing ? Have you programmed the M3 board ?

colmac New Member Posts: 2	Failed to read DCC Controller version Aug 24, 2022 0:31:23 GMT Quote Select Post Deselect Post Link to Post Member Give Gift Back to Top Post by colmac on Aug 24, 2022 0:31:23 GMT A red light flashes on the board and I have not managed to program it.

LC-DCC Designer Guest	Failed to read DCC Controller version Aug 24, 2022 8:15:13 GMT Quote Select Post Deselect Post Link to Post Back to Top Post by LC-DCC Designer on Aug 24, 2022 8:15:13 GMT The following link has all files needed: www.swws.co.uk/lc-dcc-files.html There are PDF instructions and programming files for all boards. You must first program the STM32F103 board.

Low-Cost-DCC

Failed to read DCC Controller version

Post by colmac on Aug 22, 2022 22:59:44 GMT

Post by LC DCC Designer on Aug 23, 2022 13:13:27 GMT

Post by colmac on Aug 24, 2022 0:31:23 GMT

Post by LC-DCC Designer on Aug 24, 2022 8:15:13 GMT

Quick Reply