johnh
New Member
Posts: 9
|
Post by johnh on May 1, 2023 15:12:01 GMT
I have built a quad servo DCC decoder as published in Model Railroad Hobbyist – March 2020 Can this be controlled/programmed by the low cost controller? The article described the process using the NCE cab, Digitrax, Lenz and the MRC systems but haven’t been able to get any communication with the low cost controller. Any help will be appreciated. John
|
|
|
Post by LCDCC Designer on May 8, 2023 16:56:33 GMT
Hello,
So LCDCC supports all accessory decoder NMRA protocols. This means it should be able to control the quad servo DCC decoder. I suggest you try it using the point (turnout) control within the LCDCC applications.
Regards John
|
|
johnh
New Member
Posts: 9
|
Post by johnh on May 27, 2023 7:34:00 GMT
Thanks for the reply John. As you stated the LCDCCC should work.I replaced a defective opto isolator on the decoder and I was able to move the servos via the controller.
Regards
John
|
|